Thermo Tech Inc. - We manufacture expansion joints, connectors, hoses and pipe guides

Thermo Tech, Inc. quality piping expansion, movement, and vibration “Problem Solvers” are in service in power plants, industrial facilities,
and in heating and cooling systems all over North America. Special end fittings, lengths, and pressure ratings for your application available on request. Contact the factory with your needs.

Engineered to protect your piping system from vibration and thermal expansion and contraction, our sanitary products are designed with a smooth inner surface. These sanitary connectors and hoses are ideal for Clean-In-Place (CIP) systems. They meet or exceed FDA and USDA standards.

Phone:   888.533.9988
              303.698.9988
Fax:        303.698.2184

Email
bens@thermotechdenver.com
Technical Assistance:
bens@thermotechdenver.com

Expansion Compensators


	Silicone Lined Connectors		Expansion Joints		Expansion Compensators		Flexible Metal Connectors & Hoses

	Rubber Connectors & Expansion Joints		Teflon Connectors & Flexible Hoses


				Expansion Compensator Model 200 2" Compression - 1/2" Extension Male NPT or Female Copper Sweat Ends



				Expansion Compensator Model 030 3 " Compression - 1/2" Extension Male NPT or Female Copper Sweat Ends



				Flex/Flo Pipe Alignment Guides "Spider" Type Guides Steel Pipe & Copper Tube Sizes

Thermo Tech Inc. expansion compensators accommodate the expansion and contraction of heat transfer system piping and equipment. The externally pressurized bellows construction provides an economical and reliable method of absorbing axial movement. The internal and external guide rings maintain alignment within the housing and bellows. The external housing provides protection for the bellows and components and the compact design will fit within walls and piping chases.

As with all expansion and contraction absorbing devices, piping system guides and anchors are required to prevent pressure thrust loading and buckling of the piping. Guides and anchors must be installed per EJMA specifications. Note that pipe hangers and supports are NOT guides. Guides are NOT for supporting piping. Anchors are required at each pipeline direction change, blind end, valve, major branch connection, or change in pipe diameter. End pressure thrust and anchor load requirements must always be considered in the piping system and structural design.